Passive Four Channel Stereo/Mono Mixer/Splitter Artcessories User's Manual
SPECIFICATIONS: Frequency Response: 20Hz – 20kHz, +/-1dB THD: <.005% @ 1kHz (typical) Phase Response: <10 degrees @ 20kHz Input/Out
WARRANTY INFORMATION: Limited Warranty (USA only) Applied Research and Technology will provide warranty and service for this unit in accordance wit
or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific rights and you may have other
SERVICE: The following information is provided in the unlikely event that your unit requires service. 1. Be sure that the unit is the cause of the
www.artproaudio.com E-mail: [email protected] © 2014 Applied Research & Technology SPLITMix4
SM4-5004-101 V1.1
IMPORTANT SAFETY INSTRUCTION – READ FIRST This symbol, whenever it appears, alerts you to the presence of uninsulated dangerous voltage inside en
Installation: Install the unit in accordance with the instructions printed in the user guide.
INTRODUCTION: Thank you for purchasing Applied Research and Technology’s SPLITMIX4. The SPLITMix4 is a fully passive hybrid mixer that offers a wid
headphones, and high impedance instrument pickups need an additional amplifier, but any other audio equipment should work well with the SPLITMix4. A
Application Chart
Application Chart Descriptions Figure 1. Traditional 4-in 1-out mixer with separate level control for each channel. Figure 2. 1-in 4-out “distrib
Figure 9. 4 independent signal sources feed 4 independent outputs with separate level controls on each channel.
FRONT AND REAR UNIT LAYOUT
Comments to this Manuals